NSN 5905-00-195-3283 · NIIN 001953283 · FSC 5905
NO DASHES 5905001953283
In Stock
RESISTOR,VARIABLE,WIRE WOUND,NON
Resistor
Technical characteristics
33 rows
Straight from the federal item record. Entries the record leaves empty are shown empty — nothing is filled in on its behalf.
| MRC | Requirement | Value |
|---|---|---|
| ABWV | SHAFT DIAMETER | INCHES NOMINAL 0.125 |
| ABTB | MOUNTING HOLE DIAMETER | INCHES MINIMUM 0.088 |
| ABMK | OVERALL WIDTH | INCHES NOMINAL 0.280 |
| ABJT | TERMINAL LENGTH | INCHES NOMINAL 0.500 |
| ABKW | OVERALL HEIGHT | INCHES NOMINAL 0.810 |
| TTQY | TERMINAL TYPE AND QUANTITY | PIN 3 |
| AAPN | SECTION QUANTITY | 1 |
| AAQL | BODY STYLE | |
| CQTM | TERMINAL LOCATION | LOCATION NOT OTHERWISE SPECIFIED LOWER ADJACENT SIDE TWO ROWS |
| CRFJ | TEMP COEFFICIENT OF RESISTANCE PER SECTION IN PPM PER DEG CELSIUS | SINGLE SECTION -70.0 TO 70.0 |
| CRGD | POWER DISSIPATION RATING PER SECTION IN WATTS | FREE AIR SINGLE SECTION 1.0 |
| CRSS | RESISTANCE TOLERANCE PER SECTION IN PERCENT | SINGLE SECTION -10.0 TO 10.0 |
| CRSX | ACTUATOR TRAVEL CONTROL FEATURE | CLUTCH |
| CSDH | AMBIENT TEMP IN DEG CELSIUS PER SECTION AT FULL RATED POWER | SINGLE SECTION 70.0 |
| TEST | TEST DATA DOCUMENT | DRAWING (THIS IS THE BASIC GOVERNING DRAWING, SUCH AS A CONTRACTOR DRAWING, ORIGINAL EQUIPMENT MANUFACTURER DRAWING, ETC.; EXCLUDES ANY SPECIFICATION, STANDARD OR OTHER DOCUMENT THAT MAY BE REFERENCED IN A BASIC GOVERNING DRAWING) 18876-10688566 |
| ABHP | OVERALL LENGTH | INCHES MAXIMUM 1.350 |
| AYQR | CENTER TO CENTER DISTANCE BETWEEN TERMINAL ROWS | INCHES NOMINAL 0.100 |
| CQCC | ELECTRICAL RESISTANCE PER SECTION | KILOHMS SINGLE SECTION 10.000 |
| CQCK | ROTARY ACTUATOR TRAVEL IN ANGULAR DEG | NOMINAL 9000.0 |
| CQCM | CENTER TO CENTER DISTANCE BETWEEN CENTER TERMINAL AND OUTSIDE TERMINAL | INCHES NOMINAL 0.700 |
| AXGY | MOUNTING METHOD | UNTHREADED HOLE(S) |
| ABXF | SHAFT LENGTH | INCHES NOMINAL 0.125 |
| ADAQ | BODY LENGTH | INCHES NOMINAL 1.250 |
| ADAT | BODY WIDTH | INCHES NOMINAL 0.280 |
| ADAU | BODY HEIGHT | INCHES NOMINAL 0.310 |
| AEDX | SHAFT STYLE | |
| AEFD | ACTUATOR TYPE | SINGLE SHAFT |
| AEFK | MAXIMUM STARTING TORQUE | INCH-OUNCES 0.80 |
| AEFL | MAXIMUM RUNNING TORQUE | INCH-OUNCES 0.20 |
| AEHT | CENTER TO CENTER DISTANCE BETWEEN TERMINALS | INCHES NOMINAL 0.300 |
| AGTP | LATERAL DISTANCE BETWEEN MOUNTING HOLE CENTERS | INCHES NOMINAL 1.000 |
| AKPV | MOUNTING FACILITY QUANTITY | 2 |
| CQGN | AMBIENT TEMP IN DEG CELSIUS PER SECTION AT ZERO PERCENT RATED POWER | SINGLE SECTION 175.0 |