NSN 2920-00-377-5253 · NIIN 003775253 · FSC 2920
NO DASHES 2920003775253
In Stock
GENERATOR,ENGINE ACCESSORY
Engine Electrical System Components, Nonaircraft
Technical characteristics
32 rows
Straight from the federal item record. Entries the record leaves empty are shown empty — nothing is filled in on its behalf.
| MRC | Requirement | Value |
|---|---|---|
| BZRR | THREAD SERIES | UNF |
| CMLK | MOUNTING HOLE THREAD SERIES DESIGNATOR | UNF |
| CMLL | MOUNTING HOLE THREAD DIAMETER | INCHES NOMINAL 0.500 |
| CMLM | MOUNTING HOLE THREAD QUANTITY PER INCH | 20 |
| CMLN | MOUNTING HOLE THREAD CLASS | 2B |
| CMLP | THREAD QUANTITY PER INCH | 18 |
| BCMB | ANGULAR DEVIATION OF FIRST HOLE FROM TOP CENTER IN DEG | 0.0 |
| BCMC | ANGULAR DEVIATION OF SECOND HOLE FROM FIRST HOLE IN DEG | 180.0 |
| AAJF | THREAD DIRECTION | RIGHT-HAND |
| BCLY | DISTANCE BETWEEN SHAFT CENTER AND BOTTOM MOUNTING HOLE CENTER | INCHES NOMINAL 4.875 |
| BCMD | DISTANCE BETWEEN INSIDE SURFACES OF HINGE BRACKET | INCHES MINIMUM 4.277 AND INCHES MAXIMUM 4.287 |
| BCMF | DISTANCE BETWEEN OUTSIDE SURFACES OF HINGE BRACKET | INCHES MINIMUM 5.371 AND INCHES MAXIMUM 5.381 |
| BCMG | TOP MOUNTING HOLE DIAMETER | INCHES MINIMUM 0.627 AND INCHES MAXIMUM 0.629 |
| BCGN | GROUNDING METHOD | INTERNAL |
| BCGS | SHAFT DRIVE END STYLE | |
| CFHL | THREAD CLASS | 2A |
| BCLZ | DISTANCE BETWEEN SHAFT CENTER AND TOP MOUNTING HOLE CENTER | INCHES NOMINAL 4.500 |
| AXHX | GROUND POLARITY TYPE | NEGATIVE OR POSITIVE |
| BCGD | ARMATURE MINIMUM SPEED IN RPM AT FULL CURRENT OUTPUT | 950 |
| BCGF | MAXIMUM OUTPUT CURRENT RATING IN AMPS | 55.0 |
| AWDP | THREAD DIAMETER | INCHES NOMINAL 0.625 |
| AXFH | SPLINE LENGTH | INCHES NOMINAL 2.000 |
| ELEC | VOLTAGE IN VOLTS | 12.0 |
| ZZZV | FSC APPLICATION DATA | ENGINEELECTRICAL SYSTEM,NONAIRCRAFT |
| AKCT | SHAFT ROTATION DIRECTION | CLOCKWISE |
| ADZC | ENVIRONMENTAL PROTECTION | CORROSION RESISTANT AND FUNGUS RESISTANT |
| AHZV | SUBMERSIBILITY | NONSUBMERSIBLE |
| ABSA | SPLINE QUANTITY | 6 |
| AAUK | SPLINE WIDTH | INCHES MINIMUM 0.216 AND INCHES MAXIMUM 0.217 |
| AAUJ | SPLINE MAJOR DIAMETER | INCHES MINIMUM 0.874 AND INCHES MAXIMUM 0.8745 |
| AAUH | SPLINE MINOR DIAMETER | INCHES MINIMUM 0.690 AND INCHES MAXIMUM 0.698 |
| AASA | THREAD LENGTH | INCHES NOMINAL 0.844 |