NSN 6150-01-539-4508 · NIIN 015394508 · FSC 6150
NO DASHES 6150015394508
In Stock
WIRING HARNESS
Miscellaneous Electric Power and Distribution Equipment
Application: M1A2
Technical characteristics
5 rows
Straight from the federal item record. Entries the record leaves empty are shown empty — nothing is filled in on its behalf.
| MRC | Requirement | Value |
|---|---|---|
| CXCY | PART NAME ASSIGNED BY CONTROLLING AGENCY | SIGHT CHASSIS MOLDED HARNESS ASSEMBLY |
| SPCL | SPECIAL TEST FEATURES | FABRICATE WIRE HARNESS I/A/W SPECIFICATION MIS-36532 EXCEPT ALTERNATE MOLDING MATERIAL I/A/W MIL-M-24041, TYPE I, CATEGORY B MAY BE USED |
| ZZZK | SPECIFICATION/STANDARD DATA | PROFESSIONAL/INDUSTRIAL ASSOCIATION STANDARD 80204-ANSI Y14.5--1994 |
| AGAV | END ITEM IDENTIFICATION | M1A2 |
| FEAT | SPECIAL FEATURES | CADMIUM AND CADMIUM PLATED COMPONENTS ARE NOT ALLOWED; DIELECTRIC STRENGTH: APPLY A 750 VRMS, 60HZ SIGNAL OR NOT LESS THAN 750 VDC SIGNAL FOR NOT LESS THAN 5 SECONDS TO ONE PIN OF EACH CONNECTOR WHILE GROUNDING ALL OTHER PINS WHICH ARE ELECTRICALLY ISOLATED FROM EACH OTHER; THE VOLTAGE SHALL NOT BE APPLIED TO CONDUCTORS WHICH ARE INTERCONNECTED; VERIFY THAT NO LEAKAGE OR BREAKDOWN OCCURS WHILETHE VOLTAGE IS APPLIED; ELECTRICAL RESISTANCE AND CONTINUITY: APPLY A 0.5 AMP RMS, 60HZ OR 0.5 AMP DC SIGNAL THROUGH EACH CIRCUIT AND SHIELD FOR 0.5-2.0 SECONDS AND VERIFY THAT OPERATION OF ALL CIRCUITS IS CONTINUOUS BY OBSERVING THE OUTPUT OF AN OSCILLOSCOPE |
Supersedes
This item replaces cancelled NIIN 014597245. An older drawing citing one of those numbers resolves here.