NSN 5905-00-898-2085 · NIIN 008982085 · FSC 5905
NO DASHES 5905008982085
In Stock
RESISTOR,VARIABLE,NONWIRE WOUND,
Resistor
Technical characteristics
25 rows
Straight from the federal item record. Entries the record leaves empty are shown empty — nothing is filled in on its behalf.
| MRC | Requirement | Value |
|---|---|---|
| ADAU | BODY HEIGHT | INCHES MINIMUM 0.300 AND INCHES MAXIMUM 0.330 |
| ABWV | SHAFT DIAMETER | INCHES MINIMUM 0.100 AND INCHES MAXIMUM 0.130 |
| AXGY | MOUNTING METHOD | TERMINAL |
| AEDX | SHAFT STYLE | |
| AAQL | BODY STYLE | |
| AARG | RELIABILITY INDICATOR | NOT ESTABLISHED |
| CQTM | TERMINAL LOCATION | REAR END |
| CRFJ | TEMP COEFFICIENT OF RESISTANCE PER SECTION IN PPM PER DEG CELSIUS | SINGLE SECTION -250.0 TO 250.0 |
| CRGD | POWER DISSIPATION RATING PER SECTION IN WATTS | FREE AIR SINGLE SECTION 0.8 |
| CRSS | RESISTANCE TOLERANCE PER SECTION IN PERCENT | SINGLE SECTION -10.0 TO 10.0 |
| CSDH | AMBIENT TEMP IN DEG CELSIUS PER SECTION AT FULL RATED POWER | SINGLE SECTION 85.0 |
| ABTB | MOUNTING HOLE DIAMETER | INCHES NOMINAL 0.093 |
| AEHT | CENTER TO CENTER DISTANCE BETWEEN TERMINALS | INCHES MINIMUM 0.890 AND INCHES MAXIMUM 0.910 |
| AAPN | SECTION QUANTITY | 1 |
| CBBL | FEATURES PROVIDED | NONMETALLIC SHAFT |
| TEST | TEST DATA DOCUMENT | SPECIFICATION (INCLUDES ENGINEERING TYPE BULLETINS, BROCHURES,ETC., THAT REFLECT SPECIFICATION TYPE DATA IN SPECIFICATION FORMAT; EXCLUDES COMMERCIAL CATALOGS, INDUSTRY DIRECTORIES, AND SIMILAR TRADE PUBLICATIONS, REFLECTING GENERAL TYPE DATA ON CERTAIN ENVIRONMENTAL AND PERFORMANCE REQUIREMENTS AND TEST CONDITIONS THAT ARE SHOWN AS "TYPICAL", "AVERAGE", "NOMINAL", ETC.). 81349--IL-R-22097 |
| TTQY | TERMINAL TYPE AND QUANTITY | WIRE LEAD 3 |
| ZZZK | SPECIFICATION/STANDARD DATA | GOVERNMENT SPECIFICATION 81349--IL-R-22097 TO 2 |
| CQCC | ELECTRICAL RESISTANCE PER SECTION | KILOHMS SINGLE SECTION 20.0 |
| CQGN | AMBIENT TEMP IN DEG CELSIUS PER SECTION AT ZERO PERCENT RATED POWER | SINGLE SECTION 150.0 |
| ABXF | SHAFT LENGTH | INCHES MINIMUM 0.060 AND INCHES MAXIMUM 0.080 |
| ADAQ | BODY LENGTH | INCHES MINIMUM 1.240 AND INCHES MAXIMUM 1.260 |
| ADAT | BODY WIDTH | INCHES MINIMUM 0.180 AND INCHES MAXIMUM 0.200 |
| AGTP | LATERAL DISTANCE BETWEEN MOUNTING HOLE CENTERS | INCHES MINIMUM 0.890 AND INCHES MAXIMUM 0.910 |
| AEFD | ACTUATOR TYPE | SINGLE SHAFT |
Supersedes
This item replaces cancelled NIIN 008368613. An older drawing citing one of those numbers resolves here.